![]() The user must already exist on the system in this example, I'll use the default pi user: $ sudo smbpasswd -a piįrom another computer, access: smb:///, and enter the username and password you just configured. Samba File Server on Raspberry Pi Install Samba: sudo apt-get install samba During the installation you may be asked: Modify smb. Setup Folders to Share Create a folder you wish to share on your network. sudo apt install samba -y You will be prompted Modify smb.conf to use WINS from DHCP Press Enter to select No. Possible values are listed in documentation for server max protocol option. Restart Samba so the new shared directory is available: $ sudo systemctl restart smbd Install Samba Tell the system to install Samba with the -y flag to ensure the system automatically accepts the default configuration options. 1 Answer Sorted by: 4 Use server min protocol option in smb.conf: This setting controls the minimum protocol version that the server will allow the client to use. Configure Samba to share that directoryĮdit the Samba config file with sudo nano /etc/samba/smb.conf, and add the following: I won't deal with permissions in this post read the Samba docs for that. This is important, for obvious reasons: $ sudo apt install -y samba samba-common-binĬreate a shared directory $ sudo mkdir /mnt/mydrive/shared Open Start and search for Control Panel -> Programs -> Activate or deactivate Windows features and activate SMB 1.0 / CIFS File Sharing Support. smb.conf This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. ![]() In simple terms, it allows us to access the Pi (a Linux environment based on Debian and oterhs) from a. ![]() The documentation matching the samba version installed on your system should be available with man smb.conf. In it, I'm going to document how I create Samba (SMB) shares in Linux on a Raspberry Pi. Samba is a key component for our Raspberry Pi setup. Supposedly, Sambas defaults match the following values, but I had to set them explicitly: lanman auth no ntlm auth yes client lanman auth no Share Improve this answer Follow answered at 21:06 palswim 442 2 6 24 Ran into the same issue using samba 4.8.5. Use server min protocol option in smb.conf: This setting controls the minimum protocol version that the server will allow the client to use. This is a simple guide, part of a series I'll call 'How-To Guide Without Ads'.
0 Comments
Leave a Reply. |